U-Boot 1.1.3 (Sep 13 2012 - 16:39:43) Board: Ralink APSoC DRAM: 32 MB relocate_code Pointer at: 81fb4000 ****************************** Software System Reset Occurred ****************************** spi_wait_nsec: 42 spi device id: ef 40 17 0 0 (40170000) find flash: W25Q64BV raspi_read: from:30000 len:1000 .raspi_read: from:30000 len:1000 .============================================ Ralink UBoot Version: 4.0.1.0 -------------------------------------------- ASIC 5350_MP (Port5<->None) DRAM_CONF_FROM: Boot-Strapping DRAM_TYPE: SDRAM DRAM_SIZE: 256 Mbits DRAM_WIDTH: 16 bits DRAM_TOTAL_WIDTH: 16 bits TOTAL_MEMORY_SIZE: 32 MBytes Flash component: SPI Flash Date:Sep 13 2012 Time:16:39:43 ============================================ icache: sets:256, ways:4, linesz:32 ,total:32768 dcache: sets:128, ways:4, linesz:32 ,total:16384 ##### The CPU freq = 360 MHZ #### estimate memory size =32 Mbytes Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. 4 You choosed 2 0 raspi_read: from:40028 len:6 . 2: System Load Linux Kernel then write to Flash via TFTP. Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N) Please Input new ones /or Ctrl-C to discard Input device IP (10.0.0.45) ==:10.0.0.45 Input server IP (10.0.0.10) ==:10.0.0.10 Input Linux Kernel filename (kernel.bin) ==:factory.bin netboot_common, argc= 3 NetTxPacket = 0x81FE6440 KSEG1ADDR(NetTxPacket) = 0xA1FE6440 NetLoop,call eth_halt ! NetLoop,call eth_init ! Trying Eth0 (10/100-M) Waitting for RX_DMA_BUSY status Start... done Header Payload scatter function is Disable !! ETH_STATE_ACTIVE!! Using Eth0 (10/100-M) device TFTP from server 10.0.0.10; our IP address is 10.0.0.45 Filename 'factory.bin'. TIMEOUT_COUNT=10,Load address: 0x80100000 Loading: Got ARP REPLY, set server/gtwy eth addr (00:0d:88:65:e2:fa) Got it ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################## done Bytes transferred = 5242914 (500022 hex) NetBootFileXferSize= 00500022 raspi_erase_write: offs:50000, count:500022 raspi_erase: offs:50000 len:500000 ................................................................................ raspi_write: to:50000 len:500000 ................................................................................ raspi_read: from:50000 len:10000 .raspi_read: from:60000 len:10000 .raspi_read: from:70000 len:10000 .raspi_read: from:80000 len:10000 .raspi_read: from:90000 len:10000 .blocksize write incorrect block#=4! ## Booting image at bc050000 ... raspi_read: from:50000 len:40 .Bad Magic Number,32333530 U-Boot 1.1.3 (Sep 13 2012 - 16:39:43) Board: Ralink APSoC DRAM: 32 MB relocate_code Pointer at: 81fb4000 ****************************** Software System Reset Occurred ****************************** spi_wait_nsec: 42 spi device id: ef 40 17 0 0 (40170000) find flash: W25Q64BV raspi_read: from:30000 len:1000 .raspi_read: from:30000 len:1000 .============================================ Ralink UBoot Version: 4.0.1.0 -------------------------------------------- ASIC 5350_MP (Port5<->None) DRAM_CONF_FROM: Boot-Strapping DRAM_TYPE: SDRAM DRAM_SIZE: 256 Mbits DRAM_WIDTH: 16 bits DRAM_TOTAL_WIDTH: 16 bits TOTAL_MEMORY_SIZE: 32 MBytes Flash component: SPI Flash Date:Sep 13 2012 Time:16:39:43 ============================================ icache: sets:256, ways:4, linesz:32 ,total:32768 dcache: sets:128, ways:4, linesz:32 ,total:16384 ##### The CPU freq = 360 MHZ #### estimate memory size =32 Mbytes Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. 4 You choosed 2 0 raspi_read: from:40028 len:6 . 2: System Load Linux Kernel then write to Flash via TFTP. Warning!! Erase Linux in Flash then burn new one. Are you sure?(Y/N) Please Input new ones /or Ctrl-C to discard Input device IP (10.0.0.45) ==:10.0.0.45 Input server IP (10.0.0.10) ==:10.0.0.10 Input Linux Kernel filename (kernel.bin) ==:sysupgrade.bin netboot_common, argc= 3 NetTxPacket = 0x81FE6440 KSEG1ADDR(NetTxPacket) = 0xA1FE6440 NetLoop,call eth_halt ! NetLoop,call eth_init ! Trying Eth0 (10/100-M) Waitting for RX_DMA_BUSY status Start... done Header Payload scatter function is Disable !! ETH_STATE_ACTIVE!! Using Eth0 (10/100-M) device TFTP from server 10.0.0.10; our IP address is 10.0.0.45 Filename 'sysupgrade.bin'. TIMEOUT_COUNT=10,Load address: 0x80100000 Loading: checksum bad checksum bad checksum bad checksum bad checksum bad checksum bad checksum bad Got ARP REPLY, set server/gtwy eth addr (00:0d:88:65:e2:fa) Got it ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################## done Bytes transferred = 5243693 (50032d hex) NetBootFileXferSize= 0050032d raspi_erase_write: offs:50000, count:50032d raspi_erase: offs:50000 len:500000 ................................................................................ raspi_write: to:50000 len:500000 ................................................................................ raspi_read: from:50000 len:10000 .raspi_read: from:60000 len:10000 .raspi_read: from:70000 len:10000 .blocksize write incorrect block#=2! ## Booting image at bc050000 ... raspi_read: from:50000 len:40 . Image Name: MIPS OpenWrt Linux-5.4.238 Created: 2023-04-17 13:15:36 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 1508301 Bytes = 1.4 MB Load Address: 80000000 Entry Point: 80000000 raspi_read: from:50040 len:1703cd ........................ Verifying Checksum ... Bad Data CRC U-Boot 1.1.3 (Sep 13 2012 - 16:39:43) Board: Ralink APSoC DRAM: 32 MB relocate_code Pointer at: 81fb4000 ****************************** Software System Reset Occurred ****************************** spi_wait_nsec: 42 spi device id: ef 40 17 0 0 (40170000) find flash: W25Q64BV raspi_read: from:30000 len:1000 .raspi_read: from:30000 len:1000 .============================================ Ralink UBoot Version: 4.0.1.0 -------------------------------------------- ASIC 5350_MP (Port5<->None) DRAM_CONF_FROM: Boot-Strapping DRAM_TYPE: SDRAM DRAM_SIZE: 256 Mbits DRAM_WIDTH: 16 bits DRAM_TOTAL_WIDTH: 16 bits TOTAL_MEMORY_SIZE: 32 MBytes Flash component: SPI Flash Date:Sep 13 2012 Time:16:39:43 ============================================ icache: sets:256, ways:4, linesz:32 ,total:32768 dcache: sets:128, ways:4, linesz:32 ,total:16384 ##### The CPU freq = 360 MHZ #### estimate memory size =32 Mbytes Please choose the operation: 1: Load system code to SDRAM via TFTP. 2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default). 4: Entr boot command line interface. 7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP. 0 3: System Boot system code via Flash. ## Booting image at bc050000 ... raspi_read: from:50000 len:40 . Image Name: MIPS OpenWrt Linux-5.4.238 Created: 2023-04-17 13:15:36 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 1508301 Bytes = 1.4 MB Load Address: 80000000 Entry Point: 80000000 raspi_read: from:50040 len:1703cd ........................ Verifying Checksum ... Bad Data CRC